3D Printer Lab - 204

From QC Co-Lab
Jump to navigation Jump to search

Basics

Each 3D printer is setup to use Repetier-Host for slicing and printer control. Some common profiles have been set up for usage. If you'd like to create a custom profile, please create a new one rather than edit an existing one.

Common Settings

Matter Hackers Filament Comparison Guide

Members notes

PETG does not like to be printed on bare glass. Make sure you are using blue painters tape or a glue stick.

Print PETG at a maximum of 25mm/sec. Faster speeds can cause shifting, sagging, or warping on the final pieces.