Difference between revisions of "Rostock Max Delta"

From QC Co-Lab
Jump to navigation Jump to search
(Rostock Max Delta 3D Printer)
Line 1: Line 1:
* Check the power supply in the back to make sure it's plugged in and turned on
+
== Warm Up Procedure ==
* Turn on the switch at the front, the LCD should come on and say "Printer Ready"
+
# Check the power supply in the back to make sure it's plugged in and turned on
* Hit Windows Key
+
# Turn on the switch at the front, the LCD should come on and say "Printer Ready"
* Type "Repetier"
+
# Hit Windows Key
* Run "Repetier-Host" when you see it come up
+
# Type "Repetier"
* Click the "Connect" button in the upper left hand corner
+
# Run "Repetier-Host" when you see it come up
* Click the "Manual Control" tab on the right hand side
+
# Click the "Connect" button in the upper left hand corner
* Set the bed temperature to 80 and click "Heat Printbed"
+
# Click the "Manual Control" tab on the right hand side
* Set the Extruder Temperature to 210 and click "Heat Extruder"
+
# Set the bed temperature to 80 and click "Heat Printbed"
 +
# Set the Extruder Temperature to 210 and click "Heat Extruder"

Revision as of 14:20, 3 November 2013

Warm Up Procedure

  1. Check the power supply in the back to make sure it's plugged in and turned on
  2. Turn on the switch at the front, the LCD should come on and say "Printer Ready"
  3. Hit Windows Key
  4. Type "Repetier"
  5. Run "Repetier-Host" when you see it come up
  6. Click the "Connect" button in the upper left hand corner
  7. Click the "Manual Control" tab on the right hand side
  8. Set the bed temperature to 80 and click "Heat Printbed"
  9. Set the Extruder Temperature to 210 and click "Heat Extruder"