Difference between revisions of "Rostock Max Delta"
Jump to navigation
Jump to search
(→Print Procedure) |
|||
Line 9: | Line 9: | ||
# Set the bed temperature to 80 and click "Heat Printbed" | # Set the bed temperature to 80 and click "Heat Printbed" | ||
# Set the Extruder Temperature to 210 and click "Heat Extruder" | # Set the Extruder Temperature to 210 and click "Heat Extruder" | ||
− | == | + | == Prepare Your File == |
# Click the "Load" button in the upper left hand corner | # Click the "Load" button in the upper left hand corner | ||
# Choose your STL file | # Choose your STL file | ||
Line 15: | Line 15: | ||
# Select an appropriate "Print Settings" (We don't have an official one yet, I'm using "Calibration Cube 2"). | # Select an appropriate "Print Settings" (We don't have an official one yet, I'm using "Calibration Cube 2"). | ||
# Click "Slice with "Slic3r" | # Click "Slice with "Slic3r" | ||
+ | == Print Your File == | ||
+ | # Wait until the machine is heated up by watching the temperature numbers on the manual control page | ||
+ | # Set the "Extrude" drop down on the manul control page to 10mm | ||
+ | # Click the "Extrude" button on the manual control page | ||
# Click "Run Job" in the upper left hand corner | # Click "Run Job" in the upper left hand corner |
Revision as of 15:41, 3 November 2013
Warm Up Procedure
- Check the power supply in the back to make sure it's plugged in and turned on
- Turn on the switch at the front, the LCD should come on and say "Printer Ready"
- Hit Windows Key
- Type "Repetier"
- Run "Repetier-Host" when you see it come up
- Click the "Connect" button in the upper left hand corner
- Click the "Manual Control" tab on the right hand side
- Set the bed temperature to 80 and click "Heat Printbed"
- Set the Extruder Temperature to 210 and click "Heat Extruder"
Prepare Your File
- Click the "Load" button in the upper left hand corner
- Choose your STL file
- Click the "Slicer" tab on the right
- Select an appropriate "Print Settings" (We don't have an official one yet, I'm using "Calibration Cube 2").
- Click "Slice with "Slic3r"
Print Your File
- Wait until the machine is heated up by watching the temperature numbers on the manual control page
- Set the "Extrude" drop down on the manul control page to 10mm
- Click the "Extrude" button on the manual control page
- Click "Run Job" in the upper left hand corner