Difference between revisions of "Rostock Max Delta"
Jump to navigation
Jump to search
(Created page with "== Rostock Max Delta 3D Printer ==") |
(→Rostock Max Delta 3D Printer) |
||
Line 1: | Line 1: | ||
− | + | * Check the power supply in the back to make sure it's plugged in and turned on | |
+ | * Turn on the switch at the front, the LCD should come on and say "Printer Ready" | ||
+ | * Hit Windows Key | ||
+ | * Type "Repetier" | ||
+ | * Run "Repetier-Host" when you see it come up | ||
+ | * Click the "Connect" button in the upper left hand corner | ||
+ | * Click the "Manual Control" tab on the right hand side | ||
+ | * Set the bed temperature to 80 and click "Heat Printbed" | ||
+ | * Set the Extruder Temperature to 210 and click "Heat Extruder" |
Revision as of 15:20, 3 November 2013
- Check the power supply in the back to make sure it's plugged in and turned on
- Turn on the switch at the front, the LCD should come on and say "Printer Ready"
- Hit Windows Key
- Type "Repetier"
- Run "Repetier-Host" when you see it come up
- Click the "Connect" button in the upper left hand corner
- Click the "Manual Control" tab on the right hand side
- Set the bed temperature to 80 and click "Heat Printbed"
- Set the Extruder Temperature to 210 and click "Heat Extruder"