Rostock Max Delta

From QC Co-Lab
Revision as of 14:20, 3 November 2013 by Drachs (talk | contribs) (Rostock Max Delta 3D Printer)
Jump to navigation Jump to search
  • Check the power supply in the back to make sure it's plugged in and turned on
  • Turn on the switch at the front, the LCD should come on and say "Printer Ready"
  • Hit Windows Key
  • Type "Repetier"
  • Run "Repetier-Host" when you see it come up
  • Click the "Connect" button in the upper left hand corner
  • Click the "Manual Control" tab on the right hand side
  • Set the bed temperature to 80 and click "Heat Printbed"
  • Set the Extruder Temperature to 210 and click "Heat Extruder"