Rostock Max Delta

From QC Co-Lab
Revision as of 14:41, 3 November 2013 by Drachs (talk | contribs) (Print Your File)
Jump to navigation Jump to search

Warm Up Procedure

  1. Check the power supply in the back to make sure it's plugged in and turned on
  2. Turn on the switch at the front, the LCD should come on and say "Printer Ready"
  3. Hit Windows Key
  4. Type "Repetier"
  5. Run "Repetier-Host" when you see it come up
  6. Click the "Connect" button in the upper left hand corner
  7. Click the "Manual Control" tab on the right hand side
  8. Set the bed temperature to 80 and click "Heat Printbed"
  9. Set the Extruder Temperature to 210 and click "Heat Extruder"

Prepare Your File

  1. Click the "Load" button in the upper left hand corner
  2. Choose your STL file
  3. Click the "Slicer" tab on the right
  4. Select an appropriate "Print Settings" (We don't have an official one yet, I'm using "Calibration Cube 2").
  5. Click "Slice with "Slic3r"

Print Your File

  1. Wait until the machine is heated up by watching the temperature numbers on the manual control page
  2. Set the "Extrude" drop down on the manul control page to 10mm
  3. Click the "Extrude" button on the manual control page
  4. Verify the material extruded, and clear it from the nozel.
  5. Click "Run Job" in the upper left hand corner