Vinyl cutter
Jump to navigation
Jump to search
Training Required
The vinyl cutter requires some training to operate. Please see one of the certified trainers or review the online training material listed below before operating the equipment. In-person & online training are provided at no cost to members. NOTE: those that take the online training or have prior vinyl cutting experience still need a sign off from a certified trainer to make sure the material have been covered.
Name | Contact | Certified By |
---|---|---|
David Hinkle | [email protected] | Fiat |
Keith Claussen | [email protected] | David Hinkle |
Emergency Support and Maintenance
Any issues with the cutter please see a trainer or send an email out to the list. Please do not attempt repairs without instruction. The cutter has a manufacturer's warranty until 19 Sept. 2014 & free lifetime telephone support.
Specifications
- USCutter SC Series
- 30 inch max material width
- Blade Type: Standard Roland & compatible blades
- Command sets DM-PL HP/GL automatic identification
- Motor Type: Stepper
- Interface: Serial Port & USB2.0
- Max Cutting Length: 144 in / 12 ft
- Max Downforce Pressure: 800 g
- Max Speed: 31 in/s
- Memory: 1MB - Recyclable
- Power Requirements: AC220V/110V,50Hz~60Hz
- Repetition Accuracy: 0.005IN (0.127 MM)
- Resolution: 0.001Inch/step (0.0254mm/step)
- Contour Cutting: Yes - Manual
- OS Compatibility: Windows, Mac OSX
- What it can cut: Standard Vinyl, Heat Transfer Vinyl, Paper, Craft Paper, Card Stock, Paint Mask
- What it cannot cut: Tint, Laminate, Sand Blast Resist, Low-Intensity Reflective, High-Intensity Reflective, Un-backed or un-linered media without the use of a carrier sheet